Wall Tile -  Shiny Finish

8x20

8 x 20

 

13x26

13 x 26

 

Porcelain Floor & Wall Tile - Matte Finish

12x12

12 x 12

 

12x24

12 x 24

 

Mosaic  - Matte Finish

Mosaic

2 x 2 Mosaic


Colors, Sizes & Trim

Wall Tile Sizes - Shiny  
NSMHSRW/820
8 x 20
NSMHSRW/1326 13 x 26
Wall Tile Trim
NSMHSRW/SBN 3 x 13 Surface Bullnose
NSMHSRW/A113 13” Quarter Round
NSMHSRW/AC113 Beak
Porcelain Floor & Wall Sizes - Matte
NSMHSRF/1212 12 x 12
NSMHSRF/1224 12 x 24
NSMHSRF/22 2 x 2 Mosaic
Porcelain Floor & Wall Trim
NSMHSRF/SBN 3 x 12 Surface Bullnose
NSMHSRF/A112 12” Quarter Round
NSMHSRF/AC112 Beak

Additional Information

Wall Tile

Rectified white body, shiny finish.

Wall Tile is intended for interior walls. If installing with a cement-based adhesive, we recommend using a flexible setting material. All substrates should be properly reinforced to be sure there is no movement. For mortar installations, the mortar bed has to be cured (less than 2% humidity) and has to have proper reinforcing

Wall Tile Trim

The surface bullnose is made from field that is cut, ground and then reglazed.

Porcelain Floor & Wall Sizes

Rectified glazed porcelain with a matte finish.

Mosaic

Mounted on approximately square foot sheets

Porcelain Floor & Wall Trim

The surface bullnose is made from field that is cut, ground and reglazed.

Installation

Most Italian manufactures recommend a maximum offset of 8” (20cm) on all large format tiles when setting large format tiles, ANSI A 108.2 Section 4.3.8. There are special setting requirements and materials for large format tiles. Please refer to the TCNA Handbook and guidelines by your mortar manufacturer for more information.

italygreen italyleed

testing
The Coefficient of Friction is a general guide only. Testing may vary with different production runs and with different testing labs.

As noted in the American with Disabilities Act (ADA) the coefficient of friction varies considerably due to facts not under the control of entities such as the manufacturers and distributors. These factors include, but are not limited to, contaminants, slope of terrain, drainage conditions, adjacent surfaces, etc. Suitability for any installation can only be determined by a site examination of all conditions that could affect the slip resistance of the tile being installed. Continual cleaning and maintenance must be performed once the tile has been installed. For more information see our current handout Americans with Disabilities Act and Slip Resistance of Tile.